setup
- SEL POS/ XPOS/ YPOS : Adjust the size and position of the selected area.
- RETURN : Return to the SPECIAL menu.
y DIS (Digital Image Stabilizer) : This function mitigates any picture movement due to external factors
y VIDEO ANALYTICS
If the SPECIAL menu screen is displayed,
❶
use the Function Setup switch so that the
arrow indicates 'VIDEO ANALYTICS'.
❷
Select a desired mode using the Function
Setup switch.
- TAMPERING : If the screen view is obstructed
y SENSITIVITY : Set the sensitivity to tampering detection.
y ALARM OUT : Outputting of detection signals can be set.
` OSD : Display signals on the screen.
` RETURN : Return to the TAMPERING menu.
y RETURN : Return to the VIDEO ANALYTICS menu.
`
In the following cases, the initially set tampering detection function can malfunction.
M
`
In a monitoring environment with a simple background or an environment with low light level or at night, the
detection performance can deteriorate.
`
Sudden changes in the lighting and severe camera shaking can be wrongly detected as tampering.
`
Immediately after tampering, the camera tampering detection can take up to a max of five seconds.
`
If camera tampering is detected, after some time(five sec), stabilization will be done before restarting. During
30_ setup
such as wind.
or the camera location is
changed, tampering detection,
you can issue an event signal
by setting it.
VIDEO ANALYTICS
▶
1. TAMPERING
2. MOTION
RETURN
3.
TAMPERING
SENSITIVITY
▶
1.
ALARM OUT
2.
RETURN
3.
OFF
OFF
MIDDLE