Advertisement
The installation should be done by qualified service personnel or system installers.
M
`
If the ceiling material is not strong enough to hold the installation screws, the camera
`
may fall off. Reinforce the ceiling as needed.
To change the position of the cable, take away the Hole Cover and pass the cable
`
through.
2. Hold the ceiling bracket (located where the arrow points to) and separate it from the main body
of the camera by rotating it anti-clockwise.
3. Place the separated ceiling bracket so that the "Front" side faces the area to be monitored and
install it with the M4 tapping screws.
Ceiling bracket
tapping screw
4. To combine the main body with the ceiling bracket, make sure that the pan base fixation screw
face the opposite side of the "Front" side of the ceiling bracket and rotate it clockwise.
5. Adjust the camera lens to face the area to be monitored and fix the main body and the dome
cover by rotating the body clockwise.
tapping
screw
Pan Base
fixation
screw
English_13
Advertisement
