Advertisement
setup
y DAY/NIGHT : You can display pictures in color or in black and white.
If the SPECIAL menu screen is displayed, use the Function Setup switch so that the arrow
❶
indicates 'DAY/NIGHT'.
Select a desired mode using the Function Setup switch according to the picture display
❷
you want.
- AUTO : The mode is switched to 'Color' in a
normal environment, but switches to
'B/W' mode when ambient illumination
is low. To set up the switching time
for AUTO mode, press the Function
Setup switch. You can turn on or off
the burst signal on B/W mode.
y BURST MODE : Activate or deactivate the burst mode to maintain or remove the color
y DURATION : This function is used to select the brightness of light where switching
y DWELL TIME : You can select day/night switching delay time from.
`
If you set the AGC mode to off on the exposure menu, you cannot switch the day/night mode to auto.
M
`
When a bright light source is in the screen or there are frequent brightness changes, if you use the auto night/
day mode, and set the switching time to short (3, 5 sec), a hunting can be caused. In this situation, it is
recommended to use the default setting (30 sec).
- COLOR : The picture is always displayed in color.
- B/W : The picture is always displayed in black and white.
You can turn on or off the burst signal on B/W mode.
28_ setup
signal.
occurs.
→ 3s, 5s, 7s, 10s, 15s, 20s, 30s, 40s, 60s
AUTO SETUP
BURST MODE
▶
1.
DURATION
2.
DWELL TIME
3.
RETURN
4.
ON
NORMAL
30 SEC
Advertisement
