Advertisement
expOSURe
1. When the SETUP menu screen is displayed, select 'EXPOSURE' by using the Function Setup
switch so that the arrow indicates 'EXPOSURE'.
2. Select a desired mode using the Function Setup
switch.
y BRIGHTNESS : Adjusts the video brightness.
y SHUTTER : You can select the shutter.
- MIN : 1 ~ 1/12000
- MAX : 1/60 ~ 1/12000(NTSC MODEL) ,
1/50~1/12000(PAL MODEL)
- A.FLK : Select this when you experience picture flicker, this happen when there is a clash
with the installed lighting frequency.
`
The greater the shutter value the brighter the screen is but the more the residual images of objects there are.
M
`
If the min shutter value is large, it can cause noise, spots and white areas but still operate normally.
`
If you do not use the AGC mode on the exposure menu, it cannot be set above 1/60sec(1/50sec).
`
Depending on the setting range of the minimal/maximal shutter, the screen exposure can become saturated.
y AGC (OFF/LOW/MIDDLE/HIGH) : The higher the gain level, the brighter the screen - but the
y SSNR4 : This function reduces the background noise in a low luminance environment.
- OFF : Deactivates SSNR4. Noise is not reduced.
- ON : Activates SSNR4 so that noise is reduced.
`
When adjusting the noise reduction level of the SSNR4 mode, remember that the higher the level set, th e
M
more the noise level will be reduced but that after image may also occur.
▶
BRIGHTNESS
1.
SHUTTER
2.
AGC
3.
4. SSNR4
RETURN
5.
greater the noise.
EXPOSURE SETUP
----
----
50
HIGH
ON
English_23
Advertisement
