Chapter 3 : Installation And Wiring; Installing The Vm Unit - Pro-face GP2000 Series User Manual

Vm unit

Hide thumbs Also See for GP2000 Series:

Table of Contents

Chapter 3 : INSTALLATION AND WIRING

3.1

• To prevent an electric shock, prior to the installation be sure to check

that the GP/GLC/ABS and VM Units are not connected to a power

supply.

• Do not touch the circuit board mounted on the inner face of the VM

Unit.

1. Unplug GP/GLC/ABS unit's power

cord .

2. Remove the rear face connector

cover attached to GP/GLC2000

Series Expansion Unit I/F 2 (EXT2)

or GP/ABS3000 Series VM Unit I/F.

3. Carefully insert the VM Unit into the

GP/GLC/ABS until the GP/GLC/

ABS and VM Unit connectors are

securely attached.

4. Use a screwdriver to attach each of

the VM Unit's attachment screws.

(Screws are provided with VM

Unit)

Tightening torque: 0.5 to 0.6 N•m

When installing/removing the VM Unit, be careful not to lose the attach-

ment screws.

GP2000 Series VM Unit User Manual

WARNINGS

Rear Face of GP-2500T

Connector Cover

Attachment

Screws

E3-1

Table of Contents