Rgb Input And Output Interfaces - Pro-face GP2000 Series User Manual

2.3.2

RGB Input and Output Interfaces

The VM Unit features one interface for RGB input and one for RGB output.
You can connect a Windows
You can connect a monitor or a projector to the RGB output interface.
Pin
Assignments
Dsub 15-pin
Male
1 11
5 15
• Be sure to use a straight cable that complies with VGA Impedance
Standards.
Recommended connector (plug): XM4K-1543 <made by OMRON>
Recommended cover: XM2S-0913 <made by OMRON>
Recommended RGB cables (with connectors at both ends):
FP-CV00 (2.5m) <made by Pro-face>
FP-CV01 (5.0m) <made by Pro-face>
• Connect the cables before starting up the PC/monitor and the GP/
GLC/ABS. To prevent a possible equipment malfunction, do not dis-
connect the cable while the equipment is turned ON.
• The RGB input and output connectors have similar shapes.
Confirm that the connector is correct before attaching it.
• Be sure to design your system so that length of the RGB Output cable
does not exceed 5 meters.
GP2000 Series VM Unit User Manual
®
PC or other devices to the RGB Input Interface.
Signal
Pin #
Name
1 RED Red signal input (output), Analog, Positive (0.7Vp-p: 75 Ω )
2 GREEN Green signal input (output), Analog, Positive (0.7Vp-p: 75 Ω )
3 BLUE Blue signal input (output), Analog, Positive (0.7Vp-p: 75 Ω )
4 NC No connection
5 NC No connection
6 RRED Return ground for red signal
7 RGREEN Return ground for green signal
8 RBLUE Return ground for blue signal
9 NC No connection
10 GND Ground
11 NC No connection
12 NC No connection
13 HD Horizontal synchronization signal (TTL Positive/negative)
14 VD Vertical synchronization signal (TTL Positive/negative)
15 NC No connection
Condition
E2-5