Changing Default Settings - Epson C11CF39402A0 User Manual

Roll Paper
When you turn on this mode, the printer recognizes that single sheets are not loaded in the printer.
When you press the LF/FF button, the printer does not eject the paper and continues to the next page.
Low-noise mode
When this mode is set to On, the printing speed is lowered to reduce the noise during printing.

Changing default settings

The following table shows the basic function of each button in the Default Setting mode.
Button
Menu (Pitch and Tear Off/Bin) buttons
ItemD button
ItemU button
Set button
Follow these steps to enter the Default Setting mode and change the printer's default settings:
Note:
❏ Before entering the Default Setting mode, you need to load A4 or letter size single-sheet paper or
continuous paper that is at least 210 mm (8.3 inches) wide. See "Loading Continuous Paper" on
page 21 and "Loading Single Sheets" on page 44 for instructions on loading continuous paper and
single sheets.
❏ If you use single sheets, you need to load a new sheet of paper each time the printer ejects a printed
sheet from the sheet guide.
❏ For your safety, Epson recommends operating the printer with the printer cover closed. The printer
will function with the printer cover opened or removed, but maximum safety and print speed are
achieved when the cover is closed.
❏ If you turn off the printer prior to exiting Default Setting mode, any changes you may have made are
canceled and not saved.
1. Make sure paper is loaded.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN
Basic function
Enters or exits the Default Setting mode.
Selects the next menu parameter.
Selects the previous menu parameter.
Changes the value in the selected menu.
User's Guide
Control Panel 98