Changing Default Settings - Epson C11CF39403 User Manual

Auto CR (carriage return)
This setting automatically adds a line feed (LF) code to the carriage return (CR) code.
The default setting for this feature is Off. Change this to On for systems that do not have CR code
control.
Note:
This feature is available only in IBM PPDS emulation mode.
A.G.M
Turn on the alternate graphic mode (A.G.M.) to make the ESC 3, ESC A, ESC J, ESC K, ESC L, ESC Y,
ESC Z, and ESC commands in IBM PPDS emulation mode work the same way as in ESC/P2 mode.
Note:
This feature is available only in IBM PPDS emulation mode.
Manual feed wait time
The length of wait time between the time paper is inserted into the sheet guide and when it is fed. If the
paper feeds before adjusting its position, you can increase the wait time.
Buzzer (beeper)
The printer beeps when an error occurs. (See "Using the Error Indicators" on page 103 for more
information on printer errors.) If you do not want the printer to beep when an error occurs, turn this
setting off.
Roll Paper
When you turn on this mode, the printer recognizes that single sheets are not loaded in the printer.
When you press the LF/FF button, the printer does not eject the paper and continues to the next page.
Low-noise mode
When this mode is set to On, the printing speed is lowered to reduce the noise during printing.

Changing default settings

The following table shows the basic function of each button in the Default Setting mode.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User's Guide
Control Panel 98