Epson C11CF39402A0 User Manual page 101

Note:
❏ Before entering the lock-out setting mode, you need to load A4 or letter size single-sheet paper or
continuous paper that is at least 210 mm (8.3 inches) wide. See "Loading Continuous Paper" on
page 21 and "Loading Single Sheets" on page 44 for instructions on loading continuous paper and
single sheets.
❏ For your safety, Epson recommends operating the printer with the printer cover closed. The printer
will function with the printer cover opened or removed, but for maximum safety keep the cover
closed.
❏ You can also change lock-out mode settings from the Printer Settings utility in the printer driver. See
"Changing printer setting" on page 74.
Follow these steps to change the lock-out mode setting:
1. Make sure the printer is turned off.
Caution:
!
Whenever you turn off the printer, wait at least five seconds before turning it back on;
otherwise, you may damage the printer.
2. Turn on the printer while holding down both the LF/FF and Pause buttons.
The printer enters the lock-out setting mode and prints a message asking if you wish to print all of
the current settings.
3. If you want to print the current settings, press the Set button. If you want to bypass printing of the
current settings, press the ItemD button or the ItemU button.
The printer prints the first menu and the current value of the menu.
4. Press the ItemD button or the ItemU button to select the menu parameters which you wish to
change. Press the Set button to scroll through the values within the selected parameter until you
find the desired setting. After setting the selected parameter to the desired setting, you may
continue to make changes to other parameters by pressing the ItemD button or the ItemU button.
5. Turn off the printer and exit the lock-out setting mode.
Note:
You may exit the lock-out mode by turning off the printer at any time. Any settings you have made
remain in effect until you change them again.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User's Guide
Control Panel 101