Selecting A Font And Pitch - Epson C11CF39402A0 User Manual

10. Pause button
❏ Stops printing temporarily, and resumes printing when pressed again.
❏ Press and hold for three seconds to enter Micro Adjust mode. Press the button again to exit.
11. Paper Out light
❏ On when no paper is loaded in the selected paper source or paper is not loaded correctly.
❏ Flashes when paper has not been fully ejected or a paper jam has occurred.
12. Tear Off/Bin lights
❏ Both of the two lights flash when continuous paper is in the tear-off position, and both of the lights
are off when continuous paper is not in the tear-off position.
❏ The left light is on when Card mode is selected.
❏ Both the lights are off when bin 1 of the optional cut-sheet feeder is selected.
❏ The right light is on when bin 2 of the optional cut-sheet feeder is selected.
13. Pitch lights
Indicate which pitch is selected.
14. Font lights
Indicate which font is selected.

Selecting a Font and Pitch

You can select one of the printer's fonts and pitch by using the buttons on the printer's control panel, as
described below.
Note:
❏ You can select other fonts than the eight fonts on the control panel by selecting Others. Other fonts
can be set in the Default Setting mode. See "Changing default settings" on page 98.
❏ Settings you make in application programs usually override settings you make from the printer's
control panel. For best results, use your application to select a font and make other settings.
❏ Bar code fonts cannot be selected via the control panel.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User's Guide
Control Panel 90