Printing Hex Dump - Epson C11CF39402A0 User Manual

2. To run the test using the Draft font, turn on the printer while holding down the LF/FF button. To
run the test using the printer's letter-quality fonts, turn on the printer while holding down the
Load/Eject button. Either self test can help you determine the source of your printing problem;
however, the draft self test prints faster than the letter-quality test.
3. When using single-sheet paper, load paper in the printer.
After a few seconds, the printer loads the paper automatically and begins printing the self test. A
series of characters is printed.
Note:
To temporarily stop the self test, press the Pause button. To resume the test, press the Pause button
again.
4. To end the self test, press the Pause button to stop printing. If paper remains in the printer, press
the Load/Eject button to eject the printed page. Then turn off the printer.
Caution:
!
Do not turn off the printer while it is printing the self test. Always press the Pause button to stop
printing and the Load/Eject button to eject the printed page before you turn off the printer.

Printing Hex Dump

If you are an experienced user or a programmer, print a hexadecimal dump to isolate communication
problems between the printer and your software program. In hex dump mode, the printer prints all
data it receives from the computer as hexadecimal values.
You can print a hex dump using either single sheets or continuous paper. See "Loading Continuous
Paper" on page 21 or "Loading Single Sheets" on page 44 for instructions on how to load paper.
Note:
❏ The hex dump feature is designed for a connection with DOS-based PC.
❏ Use paper that is at least 210 mm (8.3 inches) wide, such as A4 or letter size paper.
Follow these steps to print a hex dump:
1. Make sure paper is loaded and the printer is turned off.
LQ-590II/LQ-590IIN/LQ-2090II/LQ-2090IIN User's Guide
Troubleshooting 115