Table of Contents
Advertisement
Method of
reactive
6
energy
calculation
Display
7
panel illumi-
nation
Energy
8
counters
erasing
Mean acti-
9
ve power
erasing
Ordered
10
power
Default
11
settings
The automatic erasing of energy is carried out:
- for active energy when changing: voltage or current ratio;
- for reactive energy when changing: voltage or current ratio,
reactive energy calculation method;
Buttons
buttons
of the number to be set. The active position is signaled by the
cursor. Set value can be accepted by pressing the
or canceled by pressing the
be accepted, it is checked against the acceptable value range.
If the set value falls outside the allowable range, the meter
remains in parameter setting mode and the value is set to
the highest possible value (when entered value is too high)
or lowest possible value (when it is too low).
20
en_q
cAP, sIgn
oFF,1...60,
diSP
on
no, EnP, Enq,
En_0
ALL
PA_0
no, yES
PAor
0 ... 144.0
dEf
no, yES
and
and
cAP – inductive and capacity
sIgn – positive and negative
off, on, 1..60 – illumination
time (in seconds) from pres-
sing the button
no – no activity,
EnP – erase active energy,
Enq – erase reactive,
ALL – erase all energies
yES – erase power
Power ordered to establish
power consumption in % of
rated power
Reverting to default (factory)
group settings
are used for setting the values while
are used for choosing position
button. When value is to
energy
energy
cAP
on
no
no
100
no
button
Advertisement
Table of Contents
