Step 3-5: Pci Expansion Card Installation - Gigabyte GS-R114L System Installation Manual

Step 3-5: PCI Expansion Card Installation

GS-R114L provides expansion riser slots for one PCI-X full-height/full-length 64/66~100MHz; and one
with PCI-E x8 slot. To install the peripheral, please go through the following steps.
Note!!
Before installing the PCI expansion card, please check the card size limitation. Size limitation
for PCI-X full-height/full-length is 228.5 mm x 91.5 mm; size limitation for Low-Profile Card : 167.5 mm
x 56 mm .
Step 1 Lift the riser bracket slightly, then pull it out from the server chassis.
Step 2 Lossen the screw on the riser bracket.
Step 2 Align the expansion card with the guiding groove. Slide the expansion card into the slot until the
card firmly seats.
Step 3 Align the riser bracket to the system module (see the arrow direction mark 1), and push
it to locked position.
Step 4 Reverse Step 1 & 2 to lock the riser bracket firmly. Installation completed.
Step 1
Step 3
Hardware Installation Process
Step 2
Step 4
1 5