GS-SR125 Series System Installation Guide
5.7.
PCI Expansion Card Installation
GS-SR125 provides expansion riser slots for two peripheral cards,
64Bit/66 MHz full-height. To install the peripheral, please go
through the following steps.
Step 1. There are screws holding the riser bracket. Remove the
screw on the top of the bracket.
Step 2. Pull the bracket straight up. (Fig-13)
Step 2. Installing the PCI Riser card. To install the riser card, just
simply push it into the module. (Fig-14)
16
Figure 12
Figure 13