Step 2-5: Pci Expansion Card Installation - Gigabyte GS-SR275 Installation Manual

Rack mount server amd opteron socket 940 dual processor motherboard

Table of Contents

GS-SR275 Rack mount Server

Step 2-5: PCI Expansion Card Installation

GS-SR275 provides expansion riser slots for four peripheral cards, three full-heigh 64bit/66MHz PCI-X

slots and two low profile 64bit/66MHz PCI slots. To install the peripheral, please go through the following

steps.

Step 1 Remove the screws on the riser bracket.

Step 2 Detach the riser bracket with both hands.

Step 3 Installing the PCI Riser card. Align the expansion card with the guide groove. Slide the

expansion board into the slot until the board firmly seats. Repeat Step 2 & 3 to install

the remaining add-on cards.

Note:

When you insert ZCR card, the third full-heightfull-length slot can not work properly.

When you insert 1~3 expansion cards, the performance of the riser card will be 64bit/66MHz,

and if you insert 4 and more expansion cards, the preformance of riser card will be

64bit/33MHz.

Note:

To adjust the speed of expansion cards, please refer to page 25 for riser card jumper setting and

location.

Step 4 Align the stable racks to the system module (see the arrow direction mark), and push

down vertically.

Step 5 Reverse Step 1 & 2 to secure the riser bracket firmly. Installation completed.

Step 1

Step 2

1 6

Table of Contents