Table of Contents
Advertisement
Step 2-5: PCI Expansion Card Installation
GS-SR195H provides expansion riser slot for one PCI-X 64/66MHz slot; and one with PCI-E
x8 slots. To install the peripheral, please go through the following steps.
Note:
Before installing the PCI expansion card, please check the card size limitation. Size limitation for
PCI-E is listed below:
Heigth: 18.73mm(max) ; Length: 167.65mm(max) ; Width: 52mm(max)
Step 1 Loosen the riser bracket screws. Lift the riser bracket slightly, then pull it out from the server
chassis.
Step 2 Align the expansion card with the guiding groove. Slide the expansion card into the slot until
the card firmly seats.
Step 3 Align the riser bracket to the system module, and push it to locked position.
Step 4 Reverse Step 1 & 2 to lock the riser bracket firmly. Installation completed.
Step 1
Hardware Installation Process
Step 2
1 5
Advertisement
Table of Contents
