Table of Contents
Advertisement
GS-SR113 System Installation Guide
5.5. PCI Expansion Card Installation
GS-SR113 provides one expansion riser slot for two peripheral
cards, 32Bit/33 MHz full-height. To install the peripheral, please
go through the following steps.
Step 1. There are two screws holding the riser bracket. First,
remove the screw on the top of the bracket, then, remove another
screw located at the rear of the server. (Fig -12 & 13).
Figure 12
Figure 13
Step 2. Carefully pull up and remove the PCI riser bracket. (Fig-
14).
Figure 14
16
Advertisement
Table of Contents
