Preparation - Panasonic ES-LV9A Operating Instructions Manual

Preparation

Charging the shaver
• Turn the shaver off.
• Wipe off any water droplets on the main body rear terminals.
1
Insert the appliance plug into
the self‑cleaning recharger.
2
Remove the protective cap
while pressing the side of the
cap and insert the shaver into
the self‑cleaning recharger.
• Slowly insert the shaver into
the self‑cleaning recharger
taking care not to damage the
system outer foil.
3
Plug the adaptor into a household outlet.
• Check that the charge status lamp ( ) is glowing.
• Charging is completed after approx. 1 hour.
4
Disconnect the adaptor after charging is completed.
While charging
glows.
The number of the battery
capacity lamp will increase
as charging progresses.
ES-LV9A_CH.indb 35
2
3
1
After charging is completed
The battery capacity
lamp and will light up
and then turn off after
5 seconds.
Notes
• When charging the shaver for the first time or when it
has not been in use for more than 6 months, the
charging time may change or the charge status lamp
( ) may not glow for a few minutes. It will eventually
glow if kept connected.
• Recommended ambient temperature for charging is
10 – 35 °C. It may take longer to charge, or the charge
status lamp ( ) will blink quickly and the battery may fail
to charge properly in extremely high or low temperatures.
• The shaver can be used for approximately 2 weeks
with a full charge.
(Based on one 3‑minute shave use per day)
The number of usable days varies depending on the
following conditions.
- Beard thickness
- Pressure applied to the skin
- Ambient temperature
- Usage frequency of the sonic vibration cleaning mode
• If there is noise from radio or other source while using
the shaver, move to a different location to use the shaver.
35
2016/03/11 9:53:56