Advertisement
Quick Links
TABLE OF CONTENTS
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Disassembly and Assembly Instructions ---------------- 8
5 Schematic Diagram ---------------------------------------------13
6 Exploded View and Replacement Parts List -----------14
Model No.
Model No.
Model No.
Model No.
Asia
China
Middle East
PAGE
© Panasonic Corporation, 2013.
All rights reserved. Unauthorized copying and distri-
bution is a violation of law.
Order Number SD1309A37CE
Rechargeable Shaver
ES-LV95
ES-LV94
ES-LV65
ES-LV54
PAGE
Advertisement
Related Manuals for Panasonic ES-LV54
Summary of Contents for Panasonic ES-LV54
- Page 1 3 Troubleshooting Guide ----------------------------------------- 3 4 Disassembly and Assembly Instructions ---------------- 8 5 Schematic Diagram ---------------------------------------------13 6 Exploded View and Replacement Parts List -----------14 © Panasonic Corporation, 2013. All rights reserved. Unauthorized copying and distri- bution is a violation of law.
- Page 2 1 Warning Caution: • Pb free solder has a higher melting point that standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder- ing iron, please be careful not to heat too long.
- Page 3 3 Troubleshooting Guide 3.1. Main unit and charging adaptor NOTE: Once taking the battery out, the shaver is RESET. The shaver must be charged for several seconds first. NOTE: Completely discharge and then fully charge before returning the shaver to the customer.
- Page 6 4 Disassembly and Assembly Instructions 4.1. Disassembly instructions Follow the procedure below to disassemble the main unit. 1. Remove the cap, the outer foil with outer foil frame and 3. To remove the trimmer driving bar, finishing blade driving the inner blades. bar or the slit blade driving bar, press bars outward.
- Page 7 5. Take out the battery from the chassis. 7. Loosen two screws. 8. Move gently the linear motor assembly down and unhook it and remove the float springs from housing A. 6. Unsolder the lead wires from the module.
- Page 8 4.2. Caution in assembly 4. Make sure that the lead wires set in position to avoid abnormal noise. Install (+) terminal of battery into the ter- NOTE: minal plate at the bottom cover side and firmly set the bat- When reassembling, replace the new waterproof seal. tery sliding the direction of arrow.
- Page 9 6. Tighten six screws and attach the rear panel firmly. 5. When putting the housing A and the housing B together, make sure if the waterproof seal must be fitted properly and no foreign substance sticking around.
- Page 10 7. Attach the bottom cover and tighten a screw. 8. Set the trimmer driving bar, the finishing blade driving bar and the slit blade driving bar.
- Page 11 6.5. Exploded View for ES-LV65...
- Page 12 6.6. Replacement Parts List for ES-LV65 Safety Ref. No. Part No. Part Name & Description Quantity Remarks WESLV94X7158 PROTECTIVE CAP WESELV8S0047 FOIL FRAME WES9173E SYSTEM OUTER FOIL WES9170E INNER BLADE WESELV9L1007 LINEAR MOTOR ASSEMBLY WESLV90L1077 SLIT BLADE DRIVING BAR WESLV90L0327 WATERPROOF RUBBER WESLV90L1087 TRIMMER DRIVING BAR...