Changing The Port Settings For Smartdevicemonitor For Client - Gestetner C7528 Software Manual

Preparing for Printing
H
Click [IPP].
I
In the [Printer URL] box, enter "http://(printer's address)/printer"as the
printer's address.
If the server authentification is issued, to enable SSL (a protocol for encrypted
communication), enter "https://(printer's address)/printer" (Internet Explorer
5.01, or a higher version must be installed).
(example IP address: 192.168.15.16)
http://192.168.15.16/printer
https://192.168.15.16/printer
You can enter "http://(printer's address)/ipp" as the printer's address.
J
Enter a name for identifying the printer in [IPP Port Name]. Use a name dif-
ferent from the one of any existing port.
If a name is not specified here, the address entered in the [Printer URL] box
becomes the IPP port name.
K
Click [Detailed Settings] to make necessary settings.
For information about the settings, see SmartDeviceMonitor for Client Help.
L
Click [OK].
M
Check that the name of the printer whose driver you want to install is se-
lected, and then click [Next >].
N
Change the printer name if you want, and then click [Next >].
Select the [Yes] check box to configure the printer as default.
O
Specify whether or not to print a test page, and then click [Finish].
The printer driver installation starts.
P
Restart the computer to complete installation.
❒ A user code can be set after the printer driver installation. For information
about user code, see the printer driver Help.

Changing the Port Settings for SmartDeviceMonitor for Client

Follow the procedure below to change the SmartDeviceMonitor for Client set-
tings, such as TCP/IP timeout, recovery/parallel printing, and printer groups.
Windows 95/98:
A
Open [Printers] window from [Start] menu.
31