Using Netware; Setting Up As A Print Server (Netware 3.X) - Gestetner C7528 Software Manual

Using a Printer Server

Using NetWare

This section describes the setting procedure for network printers in the NetWare
environment. In the NetWare environment, you can connect the printer as a
"print server" or "remote printer".
❖ Setting procedure
• When using the printer as a print server
A
Installing SmartDeviceMonitor for Admin
B Setting the network interface board.
C
Turning the printer off and then back on.
• When using the printer as a remote printer
A Installing SmartDeviceMonitor for Admin.
B
Setting the network interface board.
C
Setting NetWare.
D Starting the print server.
❖ Using SmartDeviceMonitor for Admin
To use the printer in a NetWare environment, use SmartDeviceMonitor for Ad-
min to set the NetWare printing environment.
❒ The NetWare Client provided by Novell is required to set the printing envi-
ronment using SmartDeviceMonitor for Admin under the following environ-
ments:
• NDS mode in Windows 95/98/Me
• NDS or Bindery mode in Windows 2000/XP, Windows NT 4.0
For details about installing SmartDeviceMonitor for Admin, see
stalling SmartDeviceMonitor for
❖ Printers listed by SmartDeviceMonitor for Admin
SmartDeviceMonitor for Admin lists printers connected to the network. If you
cannot identify the printer you want to configure, print configuration page, and
then check the printer name.

Setting Up as a Print Server (NetWare 3.x)

Follow the procedure below to connect the printer as a print server using Net-
Ware 3.x.
A
Log on to the file server as a supervisor or supervisor equivalent.
Admin".
p.200 "In-
271