Setting Up As A Remote Printer (Netware 3.X) - Gestetner C7528 Software Manual

Using a Printer Server
X
Start the print server by entering the following from the console of the
NetWare server.
If the print server is in operation, quit and restart it.
❖ To exit
CAREE: unload pserver
❖ To start
CAREE: load pserver print_server_name

Setting Up as a Remote Printer (NetWare 3.x)

Follow the procedure below to use the printer as a remote printer under NetWare
3.x.
Setting up using NIB Setup Tool
A
Log on to the file server as a supervisor or supervisor equivalent.
B
Start NIB Setup Tool from [Start] menu.
C
Click [Property Sheet], and then click [OK].
D
Select the printer you want to configure, and then click [Finish].
A dialog box prompting you to perform the remaining configuration tasks in the
Web browser appears. Click [OK], and then wait until Web Image Monitor
starts automatically.
E
A dialog box for entering the user name and password appears.
Enter the user name and password, and then click OK.
❒ For details about passwords, consult your network administrator.
F
Click [Configuration] in the left area, click [Network], and then click [NetWare].
The following items are displayed:
• Print Server Name: Enter the NetWare print server name. To use the inter-
face board as a print server, enter the name of a print server that is not ac-
tive on the file server. Use up to 47 single byte characters.
• Logon Mode: Specify whether to designate a file server or NDS tree when
logging on to NetWare.
• File Server Name: When a file server name is entered here, only the spec-
ified file server is searched for. This item is mandatory. Use up to 47 single
byte characters.
278