Wiconfig - Gestetner C7528 Software Manual

Monitoring and Configuring the Printer
❖ Help URL Configuration
You can set URLs linked by clicking [Help] or [?] on Web Image Monitor.
msh> web help http://"Help URL or IP address"/help/
❖ Deleting Help URL
msh> web clear help

wiconfig

Use the "wiconfig" command to make settings for IEEE 802.11b.
❖ View settings
msh> wiconfig
❖ View IEEE 802.11b settings
msh> wiconfig cardinfo
• If IEEE 802.11b is not working correctly, its information is not displayed.
❖ Configuration
msh> wiconfig "parameter"
Parameter
mode [ap|adhoc|802.11adhoc]
ssid ID value
channel frequency channel no.
enc [on|off]
Value configured
You can set the infrastructure mode (ap) , the
802.11 Ad hoc mode (802.11 adhoc), or the
ad hoc mode (adhoc).
The default is ad hoc mode.
You can make settings for the SSID in the in-
frastructure mode.
Usable characters are ASCII 0x20-0x7e (32
bytes).
An SSID value is set automatically to the
nearest access point if no setting is made.
If no setting is made for the ad hoc mode, the
same value as for the infrastructure mode or
an ASSID value is automatically set.
You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key.
You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key.
243