Table of Contents
Advertisement
DolphinC2_ENcopy_F_FM.book Page 18 Friday, February 25, 2005 10:46 AM
Basics
❖ ❖ ❖ ❖ Inch version (Engineering)
Original width
Over than AK(8
1
and less than 9"
Over than BK(11") and
less than 12"
Over than CK(17") and
less than 18"
Over than DK(22") and
less than 24"
Over than 30" and less
than 36"
Over than EK(34") and
less than 36"
❖ ❖ ❖ ❖ Inch version (Architecture)
Original width
Over than AK(9") and
less than 11"
Over than BK(12") and
less than 17"
Over than CK(18") and
less than 22"
Over than DK(24") and
less than 34"
Over than 30" and less
than 36"
❒ The machine adjusts to a scan size
of the same paper series as the
original. If you want to mix the siz-
es of Engineering and Architecture
series when scanning, contact your
service representative.
❒ When copying custom size origi-
nals, you can use this function with
Synchro Cut to specify the copy
paper to be cut to the size of the
original.
18
Scanning
width
1
BK(11")
/
")
2
CK(17")
DK(22")
EK(34")
36"
36"
Scanning
width
BK(12")
CK(18")
DK(24")
EK(36")
36"
A A A A
Press [Orientation/Custom].
B B B B
Press [Wide Scan], and then press
[OK].
C C C C
Select the paper tray.
Note
❒ When using this function, the
Auto Paper Select function does
not work. If the paper size you
select is as the same as that of
the original, part of the image
may not be copied. Select a
slightly larger standard size.
D D D D
Place the originals, and then press
the { { { { Start} } } } key.
Setting the Carrier Sheet
Important
❒ When using the optional carrier
sheet, set the original output loca-
tion to rear original exit (straight).
If the original output location is set
to top original exit, or rear original
exit (document roller), the original
may be damaged.
Note
❒ When using the carrier sheet with
Synchro Cut selected, the paper is
cut to the size of the carrier sheet.
Reference
For details about using the carrier
sheet to make copies, see p.13
"Originals that should be scanned
using the carrier sheet".
Advertisement
Table of Contents
