Table of Contents
Advertisement
DolphinC2_ENcopy_F_FM.book Page 7 Friday, February 25, 2005 10:46 AM
Before Copying
Before you start copying, specify the original and copy paper locations.
❖ ❖ ❖ ❖ Paper Capacities For Each Original/Paper Output
Original output
Original Exit : Top
Original Exit : Rear
(Straight)
Original Exit : Rear
(document roller)
Capacities
A1 (D)L or smaller:
• Use originals that are the same size, and of medium or high qual-
ity paper.
• Do not use paper that is long length paper, thick, curled, film,
folded, or translucent paper that is less than 80 g/m
weight.
• Do not load more than 10 sheets during very hot or humid con-
ditions.
• Output thick paper (104.7 g/m
• Translucent paper: 80 g/m
2
g/m
(13.9 lb) or less, and originals that are not stiff should be
output to Rear (Straight).
A0 (E) K or smaller:
• When output originals of A1 (E)K or larger, the ejected originals
may interfere with the copy paper and impede its progress. If this
happens, use the copy output (rear) auxiliary guide.
• When copying A0 (E) Ksize originals, remove them one by one.
A1 (D)Lor larger:
• Use face-curl originals.
• For roll originals, use originals with a diameter of roll Φ40 mm –
Φ110 mm (Φ1.6" – Φ4.3").
• Do not use the document roller when copying on originals of size
longer than the maximum length for each paper type. Use both
hands to roll the original.
1. Basics
50 sheets (plain paper)
20 sheets (translucent paper)
2
(21.3 lb) in
2
(27.9 lb) or more) to Rear (Straight).
2
(21.3 lb) or less, plain paper: 52.3
1 sheet (plain paper)
1 sheet (translucent paper)
1 sheet (film)
1 sheet (up to 6 m (236")) (plain
paper)
1 sheet (up to 3.6 m (141")) (trans-
lucent paper)
1 sheet (up to 3.6 m (141")) (film)
7
Advertisement
Table of Contents
