Auto Start; Job Preset - Gestetner AO80 Operating Instructions Manual

DolphinC2_ENcopy_F_FM.book Page 23 Friday, February 25, 2005 10:46 AM

Auto Start

If you make settings and scan the
originals while the message "
ning originals can be started.
and "
Select copy mode and press
" are displayed alternately,
[Start].
your copies will be made once the
machine is ready.

Job Preset

Use this function to set up the next
copy job and scan an original when a
copy job is in progress. When the cur-
rent copy job is finished, your copy
job will start automatically.
Reference
"Job List", General Settings Guide
A A A A
Press [New Job] while "
is displayed.
B B B B
Make settings for the next copy
job.
C C C C
Place the originals. The machine
scans them.
When the current copy job finish-
es, the preset job starts automati-
cally.
Note
❒ Each job stored is allocated a job
number that is displayed on the
Reserved Job screen.
❒ To switch the display to the cur-
Scan-
"
Editing Job Preset
You can check and change the con-
tents of preset jobs. You also can de-
lete preset jobs.
A A A A
Press [Reserved Job].
B B B B
Select the number of the job you
"
Copying...
want to check or change.
C C C C
Press [Check / Change Job].
The contents of the job are dis-
played.
To check the job contents
A A A A
Check the contents of the job.
B B B B
Press [Confirmed].
The display returns to the Re-
served Job screen.
To change the job contents after
checking
A A A A
Check the contents of the job.
B B B B
Change its contents, and then press
[Confirmed].
C C C C
Press [Change].
The display returns to the Re-
served Job screen.
Basic Procedure
rent copy job press [Reserved
Job], followed by [Printing], and
then [Exit].
2
23