Table of Contents
Advertisement
DolphinC2_ENcopy_F_FM.book Page 16 Friday, February 25, 2005 10:46 AM
Basics
❒ When inserting long length orig-
inals, there may be some move-
me nt t o e it her side. If thi s
happens, correct the movement
manually while feeding the
1
originals into the machine.
C C C C
Press the { { { { #} } } } key after all origi-
nals have been scanned.
-
- To stop originals feeding in
-
-
If the originals are feeding in slanted,
or jamming, etc., press the { { { { Scanner
Stop} } } } key to stop them feeding in.
Note
❒ When you press the { { { { Scanner Stop} } } }
key, the original stops immediate-
ly, which can cause it to jam. If this
happens, see "xClearing Mis-
feeds", General Settings Guide.
❒ When you have set rear original
exit as the original output location,
the rear edge of the originals are
held at the output exit. To cancel
this, press the { { { { Scanner Stop} } } } key.
See p.8 "Original Output Loca-
tions".
16
Original Orientation
Place the original of the same orienta-
tion as the copy paper on the original
table.
1.
Feeding direction
When you cannot place the original
as the above, you may not make cop-
ies as you want with particular func-
tions. If this happens, change the
orientation by selecting [
Note
❒ It is recommended that you use
this function together with the
Auto Paper Select or Preset Re-
ZEDH150E
duce/Enlarge function.
A A A A
Press [Orientation/Custom].
B B B B
Select the original orientation,
and then press [OK].
AHD005S
] or [
].
Advertisement
Table of Contents
