Gestetner 3532 Network Manual page 89

❖ ❖ ❖ ❖ Interface Priority Configuration
You can assign priorities govern-
ing which interface obtains Au-
toNet parameters.
m s h > a u t o n e t p r i o r i t y
interface_name
Note
❒ Priority assignment is useful
when connecting more than one
interface to the machine.
❒ If an interface is not selected, the
interface appears according to
currently set priority regardless
of multiple interface connec-
tions.
interface Interface to be config-
name ured
ether Ethernet interface
*1
wlan IEEE 802.11b interface
*2
ip1394 IEEE 1394 interface
*1
If you install the 802.11b interface
kit, you can set the command.
*2
If you install the 1394 interface
board, you can set the command.
Reference
For more information about
AutoNet, see p.85 "Using Au-
toNet".
Changing the password
Use the passwd command to change
the remote maintenance password.
Important
❒ Be sure not to forget or lose the
password.
Note
❒ The default password is "pass-
word".
A A A A
Enter "passwd".
msh> passwd
Remote Maintenance by telnet
B B B B
Enter the current password.
Old password:
C C C C
Enter the new password.
New password:
Note
❒ The password must consist of
three to eight alphanumeric
characters and symbols. Pass-
words are case-sensitive. For ex-
ample, R is different from r.
❒ The password is the same as
that used in configuring the net-
work interface board with a
Web browser and that used in
NIB Setup Tool. If you change a
password from telnet, the other
passwords are also changed.
D D D D
Enter the new password once
again.
Retype new password:
SMTP
Use the smtp command to configure
SMTP (Simple Mail Transfer Proto-
col) settings.
❖ ❖ ❖ ❖ View setting
The following command displays
current SMTP settings:
msh> smtp
❖ ❖ ❖ ❖ SMTP server name configuration
The following command sets the
SMTP server name:
msh> smtp server / server_
name
The following is an example of
configurin g an IP address of
192.168.15.16 on SMTP server:
msh> smtp server 192.168.15.16
9
81