Gestetner 3532 Network Manual page 84

Appendix
❖ ❖ ❖ ❖ Bidirectional configuration for the di-
rect printing port
Use this setting to configure
whether the direct printing port is
bidirectional. The factory default is
"off".
m s h > d i p r i n t b i d i r e c t
{on|off}
Note
❒ If you select "on", SmartNet-
Monitor for Client or Standard
T C P / I P o n W i n d o w s 2 0 0 0
might not work correctly.
SPRINT
Use the sprint command to view and
configure SCSI print (SBP-2) of the
IEEE 1394.
Limitation
❒ You can use this function when the
optional IEEE 1394 board is in-
stalled.
❖ ❖ ❖ ❖ Viewing settings
The following command displays
the current IEEE 1394 (SCSI print)
settings:
9
msh> sprint
❖ ❖ ❖ ❖ Bidirectional configuration for IEEE
1394 (SCSI print)
msh> sprint bidi {on|off}
Use this setting to select whether
IEEE 1394 (SCSI print) is bidirection-
al. The factory default is "on".
76
SMB
Use the smb command to configure
or delete the computer name or work-
group name for NetBEUI.
msh> smb parameter
Parameter Settings
comp Your computer name consist-
ing of up to 15 characters
group Workgroup name consisting
of up to 15 characters
comment Comment consisting of up to
31 characters
clear comp Clears the computer name
clear group Clears the Workgroup name
clear Clears comment
comment
Note
❒ You cannot use a computer name
starting with RNP or rnp.
ROUTE
Use the route command to control the
routing table.
This command allows you to config-
ure and display routing information.
You can change the network configu-
ration from remote personal comput-
ers using this command.
Note
❒ The maximum number of routing
tables is 16.
Commands Topics of setting
route add Adds a host/network route
{host | net} to "destination", and a gate-
destination way address to "gateway" in
*1
gateway the table. Host becomes the
*1
default.