Table of Contents
Advertisement
Windows Configuration
Configuring a Windows XP
computer
These steps are for configuring a Win-
dows XP computer to use TCP/IP.
A A A A
Click the [Start] button on the
taskbar, click [Control Panel], and
then click [Network and Internet Con-
nections].
B B B B
Click [Network Connections], and
then double-click [Local Area Con-
nection].
4
C C C C
On the [General] tab, click [Proper-
ties].
Note
❒ If you want to use IEEE 1394 (IP
over 1394) interface, click [1394
Connection].
D D D D
Make sure that "Internet Protocol
(TCP/IP)" is selected in the [This
connection uses the following items]
box on the [General] tab.
Note
❒ Select TCP/IP if not already se-
lected.
❒ If TCP/IP protocol is not in-
stalled, click [Install] on the [Gen-
eral] tab to install it. For more
information about installing
TCP/IP, see Windows XP Help.
E E E E
Configure TCP/IP protocol with
the appropriate IP address, sub-
net mask and other settings.
Check with the network adminis-
trator that the settings are correct.
28
Configuring a Windows NT 4.0
computer
These steps are for configuring a Win-
d o w s N T 4 . 0 c o m p u t e r t o u s e
TCP/IP.
A A A A
Open [Control Panel], and then
double-click the [Network] icon.
Make sure that TCP/IP Protocol is
listed in the [Network protocols] box
on the [Protocols] tab.
Note
❒ If TCP/IP is not installed, click
[Add] on the [Protocols] tab to in-
stall it. For more information
about installing TCP/IP, see
Windows NT 4.0 Help.
B B B B
Configure TCP/IP with the appro-
priate IP address, subnet mask
and other settings.
Check with the network adminis-
trator that the settings are correct.
Advertisement
Table of Contents
