Ricoh 3532 Operating Instructions Manual page 19

C C C C
Gently insert paper face up into
the bypass tray until the beeper
sounds.
1.
Extender
2.
Paper guides
Note
❒ The beeper will not sound if it is
turned off. Gently insert paper
until it stops.
❒ Do not stack paper over the lim-
it mark, otherwise a skewed im-
age or misfeeds might occur.
❒ Open out the extender to sup-
port paper sizes larger than A4
L, 8 "×11" L.
1
/
2
❒ Fan the paper to get air between
the sheets to avoid a multi-sheet
feed.
❒ When setting an OHP transpar-
ency, make sure that its front
and back sides are properly po-
sitioned.
❒ Select paper type when printing
on OHP transparencies or thick
paper (over 105g/m
tails, see p.12 "Setting thick pa-
per or OHP transparencies".
D D D D
Select the paper size.
Note
❒ You can set paper size using the
printer driver. The following
procedures are not necessary
when setting paper size using
the printer driver.
❒ The paper size set using the
❒ When the printer driver is not
ZEFH061E
A Press the { { { { User Tools/Counter} } } }
B Press [Printer Features].
C Press the [Paper Input] tab.
D Press [Bypass Paper Size].
E Select the paper size.
2
). For de-
F Press [OK].
G Press the { { { { User Tools/Counter} } } }
Preparing the Printer
printer driver has priority over
that set using the display panel.
used, make settings using the
display panel.
Reference
For printer driver settings, see
the printer driver Help.
For setting custom sizes, see
p.12 "Setting custom size pa-
per".
key on the control panel.
Note
❒ Press [U U U U Prev.] or [T T T T Next] to
scroll through the list.
❒ When printing onto thick pa-
per or OHP transparencies,
select paper type. For details,
see p.12 "Setting thick paper
or OHP transparencies".
key.
2
ZCAS100N
11