Ricoh 3532 Operating Instructions Manual page 17

❖ ❖ ❖ ❖ SCSI Print (IEEE 1394) Connection
C C C C
Plug the other end of the cable
into the computer's port.
D D D D
Turn on the main power switch of
the machine.
E E E E
Turn on the computer.
Note
❒ When using Windows 95/98
SE/Me or Windows 2000/XP, a
p r in t e r d ri v e r i n s t a l la t i o n
screen might appear when the
computer is turned on. In the
above case, click [Cancel] on the
screen. For more information,
see p.14 "Auto Run".
The machine and computer is now
connected. The printer driver must
be installed next. For information
about how to install the printer
driver, see p.14 "Installing the Soft-
ware".
Connecting the Machine to the Host
Using a USB Cable
You can connect the machine to the
host computer using a USB interface
cable when the optional USB 2.0 inter-
face board is installed in the machine.
This machine does not come with a
USB interface cable. Make sure to
purchase the appropriate cable for the
machine and your computer.
Follow the procedures below to con-
nect the machine to the host computer
using a USB interface cable.
A A A A
Connect the USB 2.0 interface ca-
ble to the USB port at the right
side of the back cover of the ma-
chine.
ZHZH030J
B B B B
Connect the other end to the USB
port on the host computer.
Note
❒ The optional USB 2.0 interface
board is supported by Windows
98 SE/Me, Windows 2000/XP,
Mac OS 9.x, and Mac OS X Clas-
sic mode.
• For Windows 98 SE/Me:
Make sure to install "USB
Printing Support". When
USB 2.0 is used with Win-
d o w s 9 8 S E / M e , o n l y a
speed equal to that of USB 1.1
is possible.
• Macintosh supports only the
standard USB port. When
USB 2.0 is used with a Macin-
tosh, only a speed equal to
that of USB 1.1 is possible.
Preparing the Printer
ZHZH040J
9
2