Table of Contents
Advertisement
3.3.
EC standard compliance marking
EC standard compliance marking certifies that the product stipulated below: iSMP.
•
complies with the basic requirements of European Directive 1999/5/CE, known as the
«R&TTE Directive» concerning Radio Frequency equipment and telecommunications
terminals with respect to:
Health and safety protection of the user and all other persons
–
EMC protection
–
•
conforms to the following harmonized standards :
IEC/EN 60950-1 : Electrical safety of data processing equipment including electrical
–
office equipment. Issue DEC 2001
EN 55022 : Data processing equipment – Radio electric disturbance characteristics -
–
Limits and measurement methods. Issue 1998 / A1-2000/A2-2003
EN 55024: Data processing equipment – Immunity characteristics - Limits and
–
measurement methods. Issue 1998 + A1- 2001 + A2- 2003
•
complies with the following specification:
EN 301511 : Harmonized stand for mobile
–
EN 300328 : (BT + Wi-Fi) Electromagnetic compatibility and Radio Spectrum
–
EN 300330 : NFC Electromagnetic compatibility and Radio Spectrum
–
3.4.
FCC & IC Compliance.
FCC & IC has a specific naming.
The references uses for FCC & IC certifications are:
For Ipod touch 4
•
IC: 2586D-IMP3YY
•
FCC ID: XKB-IMP3YYW (for radio product)
•
FCC ID: XKB-IMP3YY (for product with no radio)
For the cradle:
•
FCC ID: XKB-IMP3XXCX (for cradle product)
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user's authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
iSMP for Ipod Touch 4th
900004435 R11 000 05/1120
th
version (FCC ID: BCG-E2407 and IC: 579C-E2407):
7/22
Copyright © 2011 Ingenico
All rights reserved
Advertisement
Table of Contents
