Epson WF-7211 User Manual page 29

User's Guide
Solutions:
❏ Check if MAC address filtering is disabled. If it is enabled, register the printer's MAC address so that it is not
filtered. See the documentation provided with the access point for details. You can check the printer's MAC
address from the Network Status part on the network connection report.
❏ If your access point is using shared authentication with WEP security, make sure the authentication key and
index are correct.
Related Information
"Making Advanced Network Settings" on page 23
&
"Printing a Network Status Sheet" on page 32
&
E-8
Message:
Incorrect IP address is assigned to the printer. Confirm IP address setup of the network device (hub, router, or
access point). Contact your network administrator for assistance.
Solutions:
❏ Enable DHCP on the access point if the printer's Obtain IP Address setting is set to Auto.
❏ If the printer's Obtain IP Address setting is set to Manual, the IP address you manually set is invalid due to out
of range (for example: 0.0.0.0). Set a valid IP address from the printer's control panel or by using Web Config.
Related Information
"Making Advanced Network Settings" on page 23
&
E-9
Message:
Confirm the connection and network setup of the PC or other device. Connection using the EpsonNet Setup is
available. Contact your network administrator for assistance.
Solutions:
Check the following.
❏ Devices are turned on.
❏ You can access the Internet and other computers or network devices on the same network from the devices you
want to connect to the printer.
If still does not connect your printer and network devices after confirming the above, turn off the access point.
Wait for about 10 seconds, and then turn it on. Then reset your network settings by downloading and running the
installer from the following website.
http://epson.sn > Setup
Network Settings
29