Removing The System Memory (Ram) - Clevo W970SUW Service Manual

Removing the System Memory (RAM)

The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
single or dual channel DDR3L depending on the CPU. The main memory can be expanded up to 16GB. The SO-DIMM
modules supported are 1024MB and 2048MB DDR3L Modules. The total memory size is automatically detected by the
POST routine once you turn on your computer.
Memory Upgrade Process
1. Turn off the computer, turn it over to remove the battery
2. The RAM modules will be visible at point
3. Gently pull the two release latches (
arrows (Figure 11b). The RAM module
a.
1
b.
2
(page 2 - 5) and bottom cover
on the mainboard (Figure 11b
1
& ) on the sides of the memory socket in the direction indicated by the
2 3
will pop-up ( Figure 11c ) , and you can then remove it
4
c.
4
3
(page 2 - 6).
)
.
.

Single Memory Module
Installation
If your computer has a single
memory module, then insert
the module into the Channel
0 (JDIMM1) socket. In this
case this is the horizontal
memory socket.
Removing the System Memory (RAM) 2 - 15
Disassembly
Figure 11
RAM Module
Removal
a. The RAM modules will
be visible at point 1
on the mainboard.
b. Pull the release lat-
ches.
c. Remove the module.

Contact Warning
Be careful not to touch
the metal pins on the
module's connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module's
performance.

4. RAM Module