Removing And Installing A Processor - Clevo W970SUW Service Manual

Disassembly

Removing and Installing a Processor

Figure 8
Processor Removal
Processor Removal Procedure
1. Turn off the computer, turn it over, remove the battery
a. Locate the CPU heat
sink. 2. The CPU heat sink will be visible at point
b. Disconnect the cable
3. Carefully disconnect the fan cable
and remove the screws.
4. Lift the fan
c. Remove the fan.
5. Loosen the CPU heat sink screws in the order
d. Remove the screws.
a.
b.
B

F. Fan
• 3 Screws
2 - 12 Removing and Installing a Processor
A
,and then remove the screws
B
out of the bay (Figure 8c ) .
6 F
c.
A
d.
C
D
E
(page 2 - 5) and the component bay cover
(Figure 8a).
- (Figure
C E
, &
(the reverse order as indicated on the label
3 2 1
1
2
3
(page 2 - 9).
8b) .
Figure 8d.
F