TP-Link TDW8968V3 User Manual page 82

TD-W8968
Network Authentication: Select an authentication type from the drop-down list.
Note:
For most users, it is recommended to use the default Wireless LAN Performance settings. Any
changes made to these settings may adversely affect your wireless network. Under certain
circumstances, changes may benefit performance. Carefully consider and evaluate any changes
to these wireless settings.
1. WEP
WEP is a basic encryption method offering two levels of encryption, 64-bit and 128-bit encryption.
To configure the WEP encryption, there are two ways.
•
Keep the Network Authentication of Open (insecurity) and select Enabled from the WEP
Encryption drop-down list, as shown in Figure 4-83. Open (insecurity) with WEP encryption
disable allows any wireless station to associate with the access point.
•
Select Shared (good) from the Network Authentication drop-down list, as shown in Figure
4-84. Shared (good) must enable WEP encryption. Network using Open or Shared
authentication with WEP encryption only allows stations using the same network key
encryption to associate with it. Follow the instructions below to configure the Shared Keys.
300Mbps Wireless N USB ADSL2+ Modem Router User Guide
Figure 4-82
70