Table of Contents
Advertisement
TD-W8968
2.
Select the Interface which you want to use from the drop-down list.
3.
Select the service which you want to use from the drop-down list. If the list does not have the
service you need, type the name of the custom service in the text box.
4.
Type the IP Address of the computer in the Server IP Address text box.
5.
Enter the External Port Start, External Port End, Internal Port Start and Internal Port End in
the table, and then select the protocol used for this Virtual Server, TCP, UDP or All.
6.
Click Save/Apply to enable virtual server and then you will see your setting as shown in
Figure 4-30.
Note:
If you select the service from the drop-down list, the External Port Start, External Port End,
Internal Port Start, Internal Port End and the Protocol will be added in the table automatically. You
only need to enter the Server IP Address for the Virtual Server.
4.5.6.2 Port Triggering
Choose "Advanced Setup" "NAT" "Port Triggering", you can set Port Triggering on the
screen (shown in Figure 4-32).
300Mbps Wireless N USB ADSL2+ Modem Router User Guide
Figure 4-31
38
Advertisement
Table of Contents
