Furuno SC-60 Operator's Manual page 37

Procedure
1. Open the top cover of the processor unit.
2. Open the cover of the DGPS receiver assembly.
3. Connect the cable TNCBPJ(140) to J1 on the DGPS receiver assembly.
4. Remove the plug at the rear of the processor unit.
5. Pass the cable TNCBPJ(140) through the hole made at step 4 and fasten it
with toothed washer and nut.
6. Fasten the DGPS receiver assembly at the location shown below.
Panhead Screw
M3X8, 2 pcs.
DGPS Receiver
Assembly
Cable Assembly
TNCBPJ(140)
Toothed Washer
Nut
Torque
1.37 0.98 Nm
Processor unit, cover removed, top view
7. Connect the 6P connector of the PH connector 20-061(7-6P) to J2 on the
DGPS receiver assy.
8. Connector the 7P connector of the PH connector 20-061(7-6P) to J10 on the
circuit board 20P8171.
Cover
J2
J1
Plug
2. INSTALLATION
2-23