Initial Settings; Confirming Satellite Status; Choosing Mounting Method - Furuno SC-60 Operator's Manual

2.6

Initial Settings

Follow the procedures in this section to enter initial settings.
2.6.1

Confirming satellite status; choosing mounting method

1. Turn on the processor unit and press the [MENU] key to show the menu.
2. Use the Omnipad (
3. Confirm that "MOUNTING" is selected and press the [ENT] key.
4. Use the Omnipad to choose the mounting method: "FLOOR", "WALL" or
"INVERT" as appropriate.
5. Press the [ENT] key.
6. Choose "DIRECTION" and press the [ENT] key.
7. Use the Omnipad to choose mounting direction ("A ", "B ", "C" or "D") as
appropriate. Refer to section 2.3.1.
8. Press the [ENT] key.
9. Press the [SAT STATUS] key.
Improper menu settings may stop output of
data and display the message "RATE
ERROR." Be sure to enter correct data.
) to choose "INST MENU" and press the [ENT] key.
Installation setup menu
Satellites used for
measurement
SAT TRACKING STATUS
TIMER 5 '52"
Satellites
NO.
being
GPS1 8
tracked
GPS2 7
GPS3 8
Satellite tracking status display
NOTICE
MAIN MENU
SATELLITE
ALARMS
DGPS
MESSAGES
I/O SETUP
GPS SETUP
INST MENU
SYS SETUP
ERASE
SOFT VER.
TRIP MENU
OTHERS
Main menu
INSTALLATION SETUP
MOUNTING : FLOOR
DIRECTION : A
LANGUAGE : ENG
OK
GOOD STATUS
8 D3D
7 D3D
"3D" shown when no
8 D3D
beacon receiver is used.
2. INSTALLATION
"OK" displayed when
the "GOOD" column
shows that the number
of satellites acquired is
five or more.
2-19