Installing The Antenna Units; Sc-Series Antenna Unit - Furuno SC-60 Operator's Manual

2. INSTALLATION
2.2

Installing the Antenna Units

2.2.1

SC-series antenna unit

1. Prepare a mounting platform (wood, steel or aluminum) in accordance with
the illustration shown below. If corrosive material is used, take necessary
anti-corrosion measures.
Note: When drilling holes in the platform, be sure they are parallel with the
2. Fasten the antenna unit to the platform with four sets of M10 hex. bolts,
spring washers and flat washers, orienting it as shown below. (The bow mark
( ) on the antenna should face the bow.) The torque for the hex. bolts
should be between 19.6-24.5 Nm.
Do not open the antenna.
This installation does not require removal
of the antenna cover.
2-4
Fasten the antenna to the mounting
location lastly if it is more convenient
to connect the antenna cable before
mounting the antenna unit.
fore-and-aft line.
NOTICE
240
Mounting dimensions for antenna, orienting the antenna
NOTICE
240
160
160
U
R
U
F
BOW
Fixing Hole
B
( 11 mm)
Flat Washer
Spring Washer
Hex. Bolt