Lexmark 4021 User Manual page 79

Understanding the printer menus
Use
Portrait Width
3.54–48 inches
89.9–1219 mm
Portrait Height
5.5–48 inches
139.7–1219 mm
Feed Direction
Short Edge
Long Edge
Bin Setup menu
Use
Output Bin
Standard Bin
Bin [x]*
Configure Bins
Mailbox
Link
Link Optional
Type Assignment
* [x] can be any number from 1 to 4 if the appropriate optional bins are installed. If multiple bins are assigned the
same name, then the name appears only once in the bin list.
To
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
12 inches is the U.S. factory default setting. You can increase the
width in 0.01‑inch increments.
•
305 mm is the international factory default setting. You can
increase the width in 1‑mm increments.
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
17 inches is the U.S. factory default setting. You can increase the
height in 0.01‑inch increments.
•
432 mm is the international factory default setting. You can
increase the height in 1‑mm increments.
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
To
Specify the default bin.
Note: Standard Bin is the factory default setting.
Specify configuration options for bins.
Notes:
•
Mailbox is the factory default setting. This treats
each bin as a separate mailbox.
•
Link configures all available bins as one large bin.
•
Link Optional links together all available bins
except the standard bin and only appears when
at least two optional bins are installed.
•
Type Assignment assigns each paper type to a
bin or linked bin set.
79