Lexmark 4021 User Manual page 112

Understanding the printer menus
Use
Separator Source
Tray [x]
Multipurpose Feeder
Paper Saver
Off
2‑Up
3‑Up
4‑Up
6‑Up
9‑Up
12‑Up
16‑Up
Paper Saver Ordering
Horizontal
Reverse Horizontal
Reverse Vertical
Vertical
Paper Saver Orientation
Auto
Landscape
Portrait
Paper Saver Border
None
Solid
Staple Job
Auto
Back
Dual
Front
Off
Run Stapler Test
Hole Punch
On
Off
To
Specify the paper source for the separator sheet.
Notes:
•
Tray 1 (standard tray) is the factory default setting.
•
From the Paper menu, set Configure MP to "Cassette" for Multipurpose
Feeder to appear as a menu setting.
Print multiple‑page images on one side of a paper.
Notes:
•
Off is the factory default setting.
•
The number selected is the number of page images that are printed per
side.
Specify the positioning of multiple‑page images when using Paper Saver.
Notes:
•
Horizontal is the factory default setting.
•
Positioning depends on the number of page images and whether they
are in portrait or landscape orientation.
Specify the orientation of a multiple‑page document.
Note: Auto is the factory default setting. The printer chooses between
portrait and landscape.
Print a border when using Paper Saver.
Note: None is the factory default setting.
Specify whether printed output is stapled.
Notes:
•
Off is the factory default setting.
•
This menu appears only when a supported staple finisher is installed.
Print a report that confirms that the staple finisher is functioning properly.
Note: This menu appears only when a supported staple finisher is installed.
Specify whether holes are created on printed outputs for the purpose of
collecting the sheets in a binder or folder.
Notes:
•
Off is the factory default setting.
•
This menu appears only when a supported staple, hole punch finisher is
installed.
112