Lexmark 4021 User Manual page 54

Paper and specialty media guide
–
Have bent corners.
–
Have rough, cockle, or laid finishes.
•
Adjust the width guides to fit the width of the envelopes.
•
Before loading the envelopes on the tray, flex the stack of envelopes back and forth to loosen them, and
then fan them. Straighten the edges on a level surface.
Note: A combination of high humidity (over 60%) and high printing temperature may wrinkle or seal
envelopes.
Tips on using labels
•
From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the
labels loaded in the tray.
•
Print samples on labels being considered for use before buying large quantities.
•
For more information on label printing, characteristics, and design, see the Card Stock & Label Guide on
the Lexmark Web site at http://support.lexmark.com.
•
Use labels designed specifically for laser printers.
•
Do not use labels with slick backing material.
•
Do not use labels with exposed adhesive.
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial
sheets also contaminate the printer and the cartridge with adhesive, and could void the printer and toner
cartridge warranties.
•
Before loading labels on the tray, flex and fan labels to loosen them. Straighten the edges on a level surface.
Tips on using letterhead
•
Use letterhead specifically for laser printers.
•
Print samples before buying large quantities.
•
Before loading letterhead, flex and fan the sheets.
•
When printing on letterhead, take note of the page orientation.
Source
Trays
Multipurpose feeder
Printing Side with the
letterhead
One‑sided Faceup
Two‑sided Facedown
One‑sided Facedown
Two‑sided Faceup
54
Paper orientation
Load the sheet with the
top edge toward the
back of the tray.
Load the sheet with the
top edge toward the
front of the tray.
Load the sheet with the
top edge on the left side.
Load the sheet with the
top edge on the right
side.