Lexmark 4021 User Manual page 113

Understanding the printer menus
Use
Hole Punch Mode
2 holes
3 holes
4 holes
Offset Pages
None
Between Copies
Between Jobs
Quality menu
Use
Print Resolution
300 dpi
600 dpi
1200 dpi
1200 Image Q
2400 Image Q
Pixel Boost
Off
Fonts
Horizontally
Vertically
Both directions
Toner Darkness
1–10
To
Specify the number of holes to be created on printed outputs for the purpose
of collecting the sheets in a binder or folder.
Note: This menu appears only when a supported staple, hole punch finisher
is installed.
Offset pages at certain instances.
Notes:
•
None is the factory default setting.
•
Between Copies inserts a blank sheet between each copy of a print job if
Collate is set to (1,2,3) (1,2,3). If Collate is set to (1,1,1) (2,2,2), then a blank
page is inserted between each set of printed pages, such as after all
page 1's and after all page 2's.
•
Between Jobs sets the same offset position for the entire print job
regardless of the number of copies printed.
•
This menu appears only when a supported staple finisher is installed.
To
Specify the printed output resolution in dots per inch (dpi) or image quality.
Note: 600 dpi is the factory default setting.
Enable more pixels to clarify and enhance images or text.
Note: Off is the factory default setting.
Determine the darkness of the printed output.
Notes:
•
8 is the factory default setting.
•
Selecting a smaller number can help conserve toner.
113