Table of Contents
Advertisement
Operating the appliance
en
sequence is specially adapted to each
type of stain.
Touch ã Stains and select the
appropriate type of stain.
The programme duration,
Note:
number of rinse cycles and water level
may vary, depending on the type of
stain selected.
Programme features
Once you have selected a programme,
look at the programme features.
Touch the required feature.
B Delayed start
Before the programme starts, you can
set the time at which you want the
programme to finish.
Touch B.
1.
Slide your finger along the bar until
2.
the required number of hours and
minutes are shown/the time at which
you want the programme to end is
shown.
28
Once you have set the time
Note:
on your appliance, you can set the
time at which you want the
programme to end.
If you have not set the time, you will
only be able to set when the
programme ends in hours and
30 minute increments.
Touch I.
3.
The programme end has now been
set and your programme will start
after a delay.
As long as the programme has
Note:
not yet started, you will still be able to
load more laundry or remove some
from the drum.
± Flex start
Activate the Flex start function to allow
your smart energy system (Energy
manager) to start your appliance once
your home photovoltaic system is able
to provide sufficient energy or the
energy tariff is good.
Your smart energy system
Note:
(Energy manager) cannot start your
appliance until it is connected to the
appliance.
Activating Flex start
Touch B.
1.
Slide your finger along the bar until
2.
the required time period is shown in
hours or as a clock time.
Once you have set the time
Note:
on your appliance, you can use this
to set the time period.
If you have not set the time or if you
have deactivated it, you will only be
able to set the time period in hours.
Touch I.
3.
Touch }.
4.
The Flex start function has now been
activated and the appliance will wait to
be started by the smart energy system
(Energy manager).
Advertisement
Table of Contents
