Siemens WM14U840 Series Instruction Manual And Installation Instructions page 27

Table of Contents

Advertisement

p Temperature
Before and after the programme starts,
you can change the set temperature
depending on how far through the
programme the appliance is.
The maximum temperature that can be
set depends on the programme that has
been selected.
Touch p Temperature and adjust it.
0 Spin
Before and after the programme starts,
you can change the spin speed (in rpm;
revolutions per minute) depending on
how far through the programme the
appliance is.
The maximum speed that can be set
depends on the model and programme
that has been selected.
Touch 0 Spin and adjust it.
l Extra Rinse
Additional rinse cycle for particularly
sensitive skin and/or for areas with very
soft water.
Touch l Extra Rinse and adjust it.
Additional rinse cycles extend
Note:
the duration of the programme.
! Prewash
Prewash for heavily soiled laundry.
Touch ! Prewash to activate or
deactivate it.
æ Less Ironing
Reduces creasing by means of a
special spin sequence followed by
fluffing and reduced spin speed.
Touch æ Less Ironing and activate or
deactivate it.
If æ Less Ironing has been
Note:
activated, the laundry will have retained
a higher than average level of moisture
after spinning.
Operating the appliance
z Water Plus
Increased water level for gentler
treatment of the laundry.
Touch z Water Plus to activate or
deactivate it.
ç Silent Wash
Reduced noise values thanks to a
special wash and spin cycle and
deactivated end signal. Especially
suitable for washing at night.
Touch ç Silent Wash to activate or
deactivate it.
õ Soaking
Before the main wash cycle starts, the
laundry remains in the water for longer
to remove bad soiling. To be used for
particularly stubborn soiling.
Touch õ Soaking and adjust it.
To avoid discolouration, only
Note:
soak laundry of the same colour
together.
$ Rinse Hold
The laundry remains in the rinsing water
after it has been washed.
Touch $ Rinse Hold and activate or
deactivate it.
If you have selected $ Rinse
Note:
Hold, the laundry remains in the rinsing
water after it has been washed. You
either have to spin the laundry or drain
the water in order to end the
programme. Only then can you remove
the laundry.
ã Stains
Adjusts the washing temperature, drum
movement and soaking time to the
specific type of stain.
Hot or cold water, gentle or intensive
washing and long or short soaking
ensure that the wash programme
en
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wm14u840eu

Table of Contents