Electrical Connection; Before Washing For The First Time - Siemens WM14U840 Series Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Electrical connection

:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
with wet hands.
Only pull out the mains cable by the
plug and never by the cable, as this
could damage it.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
indicated on the appliance (rating
plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The appliance is only connected to
an alternating current via a properly
installed earthed socket.
The mains plug fits the socket.
The earthing system is properly
installed.
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
extension cables are used.
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
all times.
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Positioning and connecting
Before washing for the first
time
The appliance was thoroughly tested
before leaving the factory. To remove
any water that may be left over from the
test, run the first wash cycle without any
laundry.
Notes
The appliance must be correctly
installed and connected.
Never use a damaged appliance.
Inform customer services.
Preparatory work:
Check the appliance.
1.
Fill the dispenser ß and M/ß.
2.
Plug into the mains.
3.
Turn on the tap.
4.
Run the programme without laundry.
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean programme.
3.
Open the detergent drawer.
4.
Pour approx. 1 litre of water into the
5.
dispenser for manual dosing.
Pour standard detergent into the
6.
dispenser for manual dosing.
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
designed for woollens or delicates.
Close the detergent drawer.
7.
Start the programme.
8.
When the programme ends, press
9.
the " button till the indicator lamp
turns off, release the button.
Your appliance is now ready to use.
en
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wm14u840eu

Table of Contents