Table of Contents
Advertisement
Troubleshooting
Problem Solving
Reading the Indicators
You can check the status of the projector from the flashing and lit
on the control panel.
Refer to the following table to check the projector's status and how to remedy problems shown by the
indicators.
Indicator status during an error/warning
Indicators
Replace Lamp
(blue)
(orange)
High Temp Warning
(blue)
(orange)
Status
It is time to replace your lamp. Replace the lamp with a new lamp
as soon as possible.
The lamp may explode if you continue to use it in this status.
You can continue projecting. If the temperature rises too high
again, projection stops automatically.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s
,
: Flashing
: Lit
Remedy
p.95
s
77
(operation indicators),
o
: Status maintained
p.91
,
, and
m
: Off
Advertisement
Table of Contents
