Advertisement
A
NEUVIDEO
WebGUI Overview
• STATUS:
This tab displays the current status of the various components of the unit in real-time.
• DEVICE:
This tab provides controls for all 8 power output ports as well as control over the optional external fans' speed and
temperature thresholds.
1. Power In: Displays the voltage, current and
wattage of the unit's main power supply.
2. Power Out: Displays the voltage, current and
wattage of each of the 8 individual power outputs.
3. System Temperature: Displays the unit's
temperature as measured at 3 locations inside the
case on the PCB.
4. System Fan: Displays the current state of 2
external fans (optional) including individual fan
RPM, and the current fan speed thresholds, if
auto mode is enabled.
1. Power Out: This section provides control over
each individual power output. The outputs may
be turned on, turned off, and renamed.
2. Fan Setting: This section provides controls
for any connected fans. When Auto Fan Mode is
enabled the fan speed will be controlled based
on the 3, user set, temperature thresholds and
speed selections. The preferred fan speed at
each threshold is also user configurable. If Auto
Fan Mode is disabled, the fan speed can be set
as a static percentage of maximum power. If 2
fans are connected to the unit, both will follow the
same settings.
Note: The highest of the (3) System Temperature
measurements is used to determine which Auto
Fan Mode speed (low, middle, or high) is active
when Auto Fan Mode is enabled.
7
WebGUI Control
Advertisement
